ftc-team-17240

3D Designs

We have several free, no-liscence prints that may be useful for your robotics project!

Our Camera Mount For Logitech C920; designed to work on a REV Frame

Camera Mount

Our Currect Claw; Designed to Work on a REV Servo

An image of a claw currently in use in the Iron Eagles' Robot

A Pulley Wheel That Could Be Used For the Linear Slide on Your Robot!

An image of a concave wheel, narrower in the middle than at the ends. There are two holes in the wheel: a hexagonal hole in the center which an axel is meant to pass through, and a circular hole that passes through where the eges of the wheel hang over the center. A string attaches at the smaller, circular hole

A Pulley Wheel Used For the Linear Slide on our Robot

(This is a design that is specialized for our robot, but it might not be as good for your robot as the other wheel.)

An image of a wheel with two grooves in it. The wheel has two holes: a hexagonal hole in the center that an axel passes through, and a smaller, cicular hole that a string can be attached to. The circular hole passes through the edges, which hang over the center of the wheel.

Our Possible Future Claw; Designed to Work on a REV Servo

An image of a future claw design that may or may not be used.